High Voltage Test Enclosure integr. Hipot | 10 kV large

LXinstruments LX-HVE900IS
High Voltage Test Enclosure with integrated Hipot Safety Tester 10 kV Test Enclosure, 940 x 640 x 716 mm

The large test chamber is sealed with a hood made of stable, highly insulating and transparent plastic. This gives a clear view of the DUT and the signal lamp during the test, which indicates either “green light” for safe opening or “red light” for electrical hazard inside the hood. The system is operated at the testing device. Alternatively, test sequences stored on an integrated computer may be started automatically by closing the hood. The test sequence can be followed entirely on the monitor.

A tested safety switch ensures that the hood cannot be opened during the high voltage test. The connections of the safety tester are reproduced in the rear area of the test chamber. Thus the full width is available to the DUT and it can be contacted with the original accessories of the tester. The optional safety box additionally ensures that no dangerous energy can enter the test chamber when opened.

On the side of the test enclosure there is also a power connection as well as an LAN connection for remote control or to back up test data. Another interface located on the side allows peripherals to be connected via USB and HDMI.

Features of High Voltage-Test Enclosure LX-HVE900IS

• Dimensions outer: 940 x 640 x 716 mm
• Dimensions usable space: 750 x 460 x 500 mm
• Connection customer side: IEC power connector (C18; 230 V AC; 50 Hz; 10 A)
• Permissible operating voltage: Max. 10 kV at <=2000 m above sea level in the entire useable space
• Compliance with standards: EN50191 / EN61010-1
• Material: PVC light grey / transparent
• Gas spring, ball bearing: Extremely low-maintenance components with a high number of cycles
• Integrated computer with test software and monitor in the hood
• Safety box: Additional safety circuit for Performance Level E: 3 mA current limiter is generally installed in the tester
• Individual tester selection: Depending on the measuring function
• Ready-to-use configurations available at short notice

Options of High Voltage Test Enclosure LX-HVE900IS

• Integrated computer with test software and monitor in the hood
• Safety box: Additional safety circuit for Performance Level E: 3 mA current limiter is generally installed in the tester
• Individual tester selection: Depending on the measuring function
• Ready-to-use configurations available at short notice