GW-PCS-1000i

Model GW Instek GW-PCS-1000i
Isolated High Precision Current Shunt Meter

• 6 1/2 digit voltage and current measurement resolution
• Simultaneous current and voltage measurement
• Five current measurement levels (AC&DC): 30mA/ 300mA/ 3A/ 30A/ 300A
• AC voltage measurement levels: 200mV/ 2V/ 20V/ 200V/ 600V
• DC voltage measurement levels: 200mV/ 2V/ 20V/ 200V/ 1000V
• Standard: USB & GPIB Interface

GW Instek rolls out the new GW-PCS-1000I isolated output high precision current shunt meter. GW-PCS-1000I high precision AC and DC shunt meter can simultaneously measure current and voltage with the maximum 6 1/2 measurement resolution. GW-PCS-1000I adopts five sets of independent shunt resistors to provide five current measurement levels, including 300A, 30A, 3A, 300mA and 30mA to meet the requirements of different current level measurements. Internally, GW-PCS-1000I utilizes two sets of 24bits ADCs and low temperature coefficient electronic components to mainly focus on the current measurement of power supply devices. High precision GW-PCS-1000I can be used in adjusting and calibrating instruments. Additionally, temperature variation will not cause GW-PCS-1000I to yield any measurement errors. GW-PCS-1000I can automatically select optimal measurement level with the maximum resolution so as to replace manual selection to save operational time. The GW Instek GW-PCS-1000I provides a BNC output, which can connect with an oscilloscope to directly observe current waveform variation without using a current probe. General oscilloscopes do not have isolated channels and their input and output are structured at a common point, therefore, the output load will likely result in measurement errors. GW-PCS-1000I’s isolated current output design can prevent measurement errors from an oscilloscope with non-isolated outputs. GW-PCS-1000I, a high precision AC/DC current shunt meter, not only provides USB and GPIB communications interfaces for users to remotely control the instrument but also conducts simultaneous voltage and current measurements. The SCPI communications commands of GW-PCS-1000I allow users to remotely control GW-PCS-1000I via a PC to operate measurement data readbacks.

Scope of Delivery:

• GW Instek GW-PCS-1000i Current Shunt Meter
• Power Cord
• Quick start guide
• User Manual CD
• Calibration Certificate
• Alligator Clip Test Lead (3A) x 1
• Banana Plug Test Lead
• USB Cable
• Basic Accessory Kit

Optional Accessories (not included):

• GRA-419-J: RackMountAdaptor (JIS)
• GRA-419-E: RackMountAdaptor (EIA)